My M1300 has recently started to go into hiberna

dmc · 12-15-2005, 06:04 AM

My M1300 has recently started to go into hibernation after a few minutes of inactivity. I have it set on Motion Power Management and am using it pluged into the charger. Anyone have any suggestions?

Dennis

Malorkus · 12-15-2005, 04:03 PM

This was a bug caused by older Wacom pen drivers I think. Do you have the latest installed? I think you may also need to update to the latest Motion BIOS.

dmc · 12-19-2005, 03:16 AM

I have the latest drivers from the Motion site but it still spontaneously goes into hibernation when it sits idle for a couple of minutes, however if I am using for a long period of time it does not go into hibernation. Any thoughts?

paulrr · 12-19-2005, 05:40 AM

Hi,

Try checking your Power properties via the Motion Dashboard
Tap on Properties
Check out the System Hibernates settings ...

dmc · 12-19-2005, 05:55 AM

I have it set to never Hibernate when plugged in and after 1 hour when running on batteries.

paulrr · 12-19-2005, 10:25 PM

What BIOS and Dashboard version are you running?

dmc · 12-20-2005, 01:56 AM

I am running Dashboard 2.0.0.7 and Bios A06

paulrr · 12-20-2005, 05:34 AM

Interesting...

Only thing I can further reccomend is rollback the DB to a previous version or go to a restore point and see if that helps or call support and see if they can assist...

sorry...

dmc · 12-21-2005, 06:24 AM

Paul thnk you for your help. It seems odd that it works fine after I have been using it for an hour or so, it only goes into spontaneous hibernation durning the first couple of hours of turning it on.